Anonymous

Gearshift Gaiter Finial-trial!

Here’s where to discuss anything specific about your standard(ish) car or something that applies to the model in general.
Post Reply
Howard722
Rust Hunter
Posts: 176
Joined: 25 Feb 2008 07:22
Location: United Kingdom
Contact:

Gearshift Gaiter Finial-trial!

Postby Howard722 » 02 Oct 2021 13:41

I managed to measure just enough of an original rubber finial to generate a drawing and now have three `first-offs` made on a 3D printer.
I have fitted one to an old gaiter,( kept back from scrapping to keep as a pattern )-see pics,
(the central bore is 1/2" -my shaft is 7/16"!!! , - so not as big as the 15mm I just about measured on the original rubber one to make it a bit stronger at the neck).
Attachments
tr7finial (1).JPG
tr7finial (1).JPG (139.87 KiB) Viewed 2217 times
tr7finial (2).JPG
tr7finial (2).JPG (157.85 KiB) Viewed 2217 times
Enjoy & regards

Rich K
Wedge Pilot
Posts: 277
Joined: 08 Aug 2015 18:04
Location: Worcester, United Kingdom

Re: Gearshift Gaiter Finial-trial!

Postby Rich K » 02 Oct 2021 22:08

Nice one. Looks good.
1980 TR7 drophead now repainted and started refitting plus V8 upgrade
1977 TR7 fixedhead awaiting restoration
1981 TR7 drophead bodywork now done, mechanicals next then final paint
Ford Ranger Wildtrak
Jaguar XKR Supercharged

Post Reply

Who is online

Users browsing this forum: No registered users and 94 guests

cron