Water Pump AGAIN
Posted: 16 Apr 2015 17:53
by g4zur
Hi all, just a quick one here. Have read on hear lots of posts about the dreaded water pump. Learned so much, yet again. I have stripped all off and can see pump in housing. Seized in of course. One question, If I turn the top bolt "left hand thread" tight and keep trying to tighten it. WILL IT SPIN OUT? without doing any more damage to anything.
Many thanks as always.
Regards Gareth.
G.P.Albrighton
Posted: 16 Apr 2015 18:00
by FI Spyder
The bolt will break.
http://www.forum.triumphtr7.com/topic.asp?TOPIC_ID=12004&whichpage=1&SearchTerms=water,pump
Use a slide hammer to remove it or some have done it by bolt and arm across opening. Do search.
- - -TR7 Spider - - - 1978 Spitfire- - - - 1976 Spitfire - - 1988 Tercel 4X4 - Kali on Integra - 1991 Integra - Yellow TCT
Posted: 17 Apr 2015 00:25
by jclay (RIP 2018)
Remove said bolt. Buy a large hefty flat washer. Take them to a welder and have him grind one edge of the washer down flat, Stand it perpendicular on the top of the bolt head. weld it into place. Put it back into the water pump and use a slide hammer with a hock to go through the hole in the washer. Two or three good whacks with the slide hammer and it should pop out.
Clay
[url="http://www.jclay.me/"]My Triumph Site[/url], [url="http://www.triumphtechnical.me"]Technical Stuff[/url], [url="https://docs.google.com/folder/d/0B8MWEvqOpX3udEF4SmFQUW9RS09hbU5uNW5Wd0xrUQ/edit"]My Public Folder[/url],