Page 1 of 1
oil pressure guage
Posted: 11 May 2009 03:05
by Mikey
I remember looking at a very interesting procedure for installing an oil pressure guage in place of the TR7 clock. I have done a search on this subject and can access the site it was published on but cannot seem to retrieve the actual instructions/photos. Can anyone help? Thanks in advance.
Posted: 11 May 2009 03:12
by Rich in Vancouver
Installing an oil pressure guage is a very simple procedure.
I used a Smith's guage less it's trim ring and lens. I removed the instrument pod and took out the clock. Using my Dremel tool with a cutting disc I cut off the back of the clock housing. I used the Smith's guage bracket to mount tha guage but cut off it's legs. The whole project just took a couple of hours and looks factory. I even get good lighting on the guage with my "Odd" instrument lights.[:)]
Rich
1975 TR7 ACL764U
Posted: 11 May 2009 03:26
by Mikey
Thanks Rich. I just purchased a Smith's guage on ebay. Does the trim ring just sort of pry off? Also, the guage I bought needs a sending unit. Any suggestions?
Posted: 11 May 2009 12:47
by jclay (RIP 2018)
Here you go!
[url="http://web.mac.com/jclaythompson/iWeb/Technical/Oil_Pressure_Gauge.html"]Installing the oil pressure gauge.[/url]
jclay
[url="http://web.mac.com/jclaythompson/iWeb/Site/Welcome.html"]My Triumph Site[/url], [url="http://web.mac.com/jclaythompson/iWeb/Technical/Intro.html"]Technical Stuff[/url], [url="http://homepage.mac.com/WebObjects/FileSharing.woa/53/wo/HJMTK8gsojtwKleP.1/0.2.1.2.26.31.97.0.35.0.1.1.1?user=jclaythompson&fpath=Triumph_Articles&templatefn=FileSharing4.html"]Download Page[/url]