Postby Rich K » 02 Nov 2021 10:10
Hi,
I don’t have pictures as the seats are not yet refitted in my car, however the parts diagram may help. The thick washer (WM809) goes between the floor and the seat runner assembly on the outside rear position. The metal seat runner stop (ZKC1620) goes between the floor and seat runner assembly on the inside rear position. ZKC1620 and washer WP181 from memory are welded together as one item on my car; not sure if all are like this. The rectangular spacers sit on top of the seat runner assembly where the star drive bolts go through the assembly into the floor. The plastic pieces were only fitted to late cars as far as I am aware, one each side at the front, over the carpet where the floor meets the transmission tunnel. These are fixed with self tapping screws through the carpet into the floor.
Hope this is helpful.
Cheers, Rich.
-
Attachments
-
- 59570A91-E37F-4444-8267-0A2DF74E6C73.jpeg (104.62 KiB) Viewed 4081 times
1980 TR7 drophead now repainted and started refitting plus V8 upgrade
1977 TR7 fixedhead awaiting restoration
1981 TR7 drophead bodywork and mechanicals now done, completing trim currently.
Ford Ranger Wildtrak
Jaguar XKR Supercharged