Page 1 of 1
5 speed gear box
Posted: 01 Jul 2010 00:38
by Johnluss
I have read on the forum that many are using the Pennzoil Synchromesh. I have bought the Quaker State Synchromesh. Is it the same spec?
Thanks
Posted: 01 Jul 2010 00:56
by V8Wedgehead
I know the Penzoil is the direct replacement for the GM fluid that is used for the LT77. I dont know anything about Quaker State though.
Michael
1980 TR8 FHCs; Rally Conversion #0020 & Stock #0058
"If it is broken then fix it....if it is not then make it faster!"
Posted: 01 Jul 2010 11:45
by Underdog
FWIW, I recently went shoping for some trans fluid for a customers MGB as he had mentioned wanting a synthetic. I tried 3 parts stores including a NAPA and Advance. Not one had any manual trans specific fluid. Several varietys of ATF and regular gear oil but no MT fluid. I found this rather strange. I get a discount on the GM stuff and have been using it. I run ATF in the B with OD. My guess is the Quaker State will be fine as long as the viscosity is thin like the other brands.
Jim Underwood
72 MGB BRG
80 TR8 Persian Aqua
If women don't find you handsome, they should at least find you handy.
Posted: 01 Jul 2010 13:08
by Workshop Help
Good Morning, Johnluss! We offer our heartfelt thanks to your volunteering to be the guinea pig for the lab testing of the Quaker State MTF in your LT77. As we are now in the midst of summer on this side of the equator, we look forward to your reports on the 1st to 2nd gear shift, the smoothness of the 3rd to 2nd gear downshift, changes in gear whine, and the amount of swarf production in the gearbox sump.
What kind of gearbox oil were you using before the change to the Quaker State?
Mildred Hargis
Posted: 01 Jul 2010 14:32
by Johnluss
Thanks Mildred but I don't like very much being the guinea pig but I will report my findings. I do not remember what I was using before but getting in second gear cold was difficult (I have heard that somewhere before) also the downshifting from 3rd to 2nd. I will check also for the gear whine (I have a musical ear). But your "swarf production" worries me. I did not intend to drain it for a few years.
<blockquote id="quote"><font size="1" face="Century Gothic, Verdana, Arial, Helvetica" id="quote">quote:<hr height="1" noshade id="quote"><i>Originally posted by Mildred</i>
Good Morning, Johnluss! We offer our heartfelt thanks to your volunteering to be the guinea pig for the lab testing of the Quaker State MTF in your LT77. As we are now in the midst of summer on this side of the equator, we look forward to your reports on the 1st to 2nd gear shift, the smoothness of the 3rd to 2nd gear downshift, changes in gear whine, and the amount of swarf production in the gearbox sump.
What kind of gearbox oil were you using before the change to the Quaker State?
Mildred Hargis
<hr height="1" noshade id="quote"></font id="quote"></blockquote id="quote">
Posted: 02 Jul 2010 01:11
by Johnluss
I made the test drive earlier and it is shifting and running very smoothly. I had problem before shifting from 1 to 2 and 3 to 2.
But I think that the leaking is worse, oil being more fluid.
Posted: 02 Jul 2010 01:45
by silverseven
I also just did the syncromesh fluid swap for the first time(work for GM , got the stuff for cost + 10%)
Did notice a incredible amount of "swarf" in the drain plug [:0], but havn't noticed any new seepage yet....mind you it's only been short trips so far, the 300km road trip is coming in two weeks......
Probably flush out the trans again over the winter,(i don't plan on doing a heck of a lot of milage this year) will be curious to see if there is the same amount of swarf this time.
Ron.


Posted: 02 Jul 2010 02:23
by FI Spyder
I use the Pennzoil synthetic synchromesh GL4 as the local Lordco had it in stock. I didn't have any more oil leakage but then I didn't have any before. When I drained the old oil out (that had been in there from 1999 at least) there was very little swarf on the plug. I wondered what all these people were talking about on the forum.
When I drained Yellow TCT in prep for removing engine/trans there was a lot of swarf on the plug (the oil had a green tinge to it due to type/make of oil). There was gold tinged metallic swerls in it so I expect some syncro wear. I has only 30,000 miles so I didn't/didn't expect too much wear but I will open it up when it's out.
TR7 Spider - 1978 Spifire - 1976 Spitfire - 1988 Tercel 4X4 - Kali on Integra - 1991 Integra

Posted: 02 Jul 2010 02:37
by Johnluss
Sorry for my ignorance but what is exactly the "swarf"? It is not in the dictionary.
Posted: 02 Jul 2010 05:23
by Rich in Vancouver
Technical term for the little bits of metal machined off parts during production or while in service.
Does anyone have experience with "Import" grade ATF in an LT-77?
I filled my gearbox with it last year with good results so far but I'm not sure it was the best choice.
Rich
1975 TR7 ACL764U

Posted: 02 Jul 2010 12:48
by Workshop Help
Please refer to my article on gearbox oil change that can be found by clicking on the SEARCH function at the top right of your screen. Photos in living color will be displayed along with witty yet pithy commentary for your amusing learning experience.
The swarf is in the sump of your LT77 and magneticly stuck to your drain plug.
Mildred Hargis
Posted: 03 Jul 2010 00:00
by Johnluss
Mildred I cannot find your article on the search function but I am interested in reading it. Can you repost it.
Thanks
<blockquote id="quote"><font size="1" face="Century Gothic, Verdana, Arial, Helvetica" id="quote">quote:<hr height="1" noshade id="quote"><i>Originally posted by Mildred</i>
Please refer to my article on gearbox oil change that can be found by clicking on the SEARCH function at the top right of your screen. Photos in living color will be displayed along with witty yet pithy commentary for your amusing learning experience.
The swarf is in the sump of your LT77 and magneticly stuck to your drain plug.
Mildred Hargis
<hr height="1" noshade id="quote"></font id="quote"></blockquote id="quote">
Posted: 03 Jul 2010 01:27
by silverseven
Posted: 05 Jul 2010 02:15
by Johnluss
Thanks.
<blockquote id="quote"><font size="1" face="Century Gothic, Verdana, Arial, Helvetica" id="quote">quote:<hr height="1" noshade id="quote"><i>Originally posted by silverseven</i>
here's a couple of links Jean
http://forum.triumphtr7.com/topic.asp?TOPIC_ID=7091&SearchTerms=transmission
http://forum.triumphtr7.com/topic.asp?TOPIC_ID=9132&whichpage=1&SearchTerms=transmission
Ron.

<hr height="1" noshade id="quote"></font id="quote"></blockquote id="quote">