tr7triumph.com

I just installed the window unit to the rails and Window
after I took it apart and cleaned greased ,took the Sextagon out so I could connect the Generic power window motor.

????IS there supposed to be something that stops it at the top end and the bottom end of the cycle????

Mine goes all the way up till it gets out of the window

And down till it falls to the door.

I must be missing something???

??? I also have anothere problem ??
WHen I roll it up by hand it slides down easy by it self or if i push on it .??

I left something Out??

I am including some pisc .

[B)]
I WILL FINISH
IT WILL START
IKNOW ICAN
IKNOW ICAN
IKNOW ICAN[:D]

Zekow1,

Your top stop is installed as I can see the two screw heads in the photo. The bottom stop is the crimp in the gear in the original winding mechanism.

I would suggest that you install micro switches that stop the current flowing to the motor when a certain position is reached.

Window falling down, sounds like the weight of the window is overpowering the motor drive and turning the motor, allowing the window to go down.

jclay

[url="http://web.mac.com/jclaythompson/iWeb/Site/Welcome.html"]My Triumph Site[/url], [url="http://web.mac.com/jclaythompson/iWeb/Technical/Intro.html"]Technical Stuff[/url], [url="http://homepage.mac.com/WebObjects/FileSharing.woa/53/wo/HJMTK8gsojtwKleP.1/0.2.1.2.26.31.97.0.35.0.1.1.1?user=jclaythompson&fpath=Triumph_Articles&templatefn=FileSharing4.html"]Download Page[/url]

Grimp I get
The two screws????
if they are installed how come it still pops out??

<blockquote id="quote"><font size="1" face="Century Gothic, Verdana, Arial, Helvetica" id="quote">quote:<hr height="1" noshade id="quote"><i>Originally posted by zekow1</i>

The two screws????
if they are installed how come it still pops out??
<hr height="1" noshade id="quote"></font id="quote"></blockquote id="quote">

The two bolts (screws) are the silver looking bolt heads in your picture in the upper indent on door. Make sure the up stop is right way on, it contacts the lower metal rail of the window preventing it from going higher. It is adjusted so top of window just fits into the rubber corner block on the quarter window.


TR7 Spider - 1978 Spifire - 1976 Spitfire - 1988 Tercel 4X4 - Kali on Integra - 1991 Integra

Got it ,Thanks guys
I must have the piece that goes in there ,somewhere.
i will seach and I will find.
If not ??I will just place a big screw and bolt.[:D]

Thanks guys
I found it
it was in the bottom of the barrel inside a plastic bag with a note:
window stopermagige.
here is a picture for future reference.
[;)]